Jump to content
APC Forum

flash powder


sepehr1

Recommended Posts

image.png.1a279b7b78fcac4eaaa3402c355e2500.png

hello found this in  an old book is this a good fp composition i was planning to prepare 1 gram of it for a firecracker

Link to comment
Share on other sites

If you are begineer and new stay away from flash.

Read flash powder safety notes first.

It works well but  stay away if you dont have experience.

Link to comment
Share on other sites

43 minutes ago, Zumber said:

If you are begineer and new stay away from flash.

Read flash powder safety notes first.

It works well but  stay away if you dont have experience.

I know that I should use the diaper method stay away from electronics and metals use PPE and anti-static and be very gentle with the powder isn't it enough?

Link to comment
Share on other sites

Are you begineer?

Link to comment
Share on other sites

1 minute ago, Zumber said:

Are you begineer?

yes but i have done some research

 

Link to comment
Share on other sites

Then dont just attempt to prepare any kind of flash.

Any Flash powder is extremely energatic and detonates if confined burns at extreme speed in open and friction and impact sensitivity and most important is aluminium powder.

Stay away and try out black powder type formulations.

Its not the right time to go for flash.

Link to comment
Share on other sites

Just now, Zumber said:

Then dont just attempt to prepare any kind of flash.

Any Flash powder is extremely energatic and detonates if confined burns at extreme speed in open and friction and impact sensitivity and most important is aluminium powder.

Stay away and try out black powder type formulations.

Its not the right time to go for flash.

Ok thank u for your advice, but I once made a little batch of kno3/AL/s flash it just burnt at slow rate just generated some sparks and a Bright light

Link to comment
Share on other sites

Okay but it should be discussed in HE section ( Correct me ).

As you are begineer.

Stay safe.

Link to comment
Share on other sites

4 minutes ago, Zumber said:

Okay but it should be discussed in HE section ( Correct me ).

As you are begineer.

Stay safe.

Are you sure HE means explosives that travel over 5000 sq km per second and produce gas too

Link to comment
Share on other sites

I am not sure but flash powder topic for begineer has been locked last week.

 

Link to comment
Share on other sites

kno3/AL/s flash can also be very,very energetic if confined a bit.... stay safe!

Link to comment
Share on other sites

  • Mumbles locked this topic
Guest
This topic is now closed to further replies.
×
×
  • Create New...