Jump to content
APC Forum

New white sparkler stars experiment


JTO

Recommended Posts

This summer I tried to mill 500g or Mg shavings into fine powder, but after 3 weeks I gave up because the stuff is impossible to mill. I ended up with very coarse powder, like kids' sandbox sand. I though I might try it in some sparkle effects, so I made two test batches of stars where I replaced some of the Al in my white star composition, in one batch I replaced 25% of the Al and in the other 50%. Here is a video of the results, the 25% mix is in the left, the 50% mixture on the right. These are 1 gram stars, 5 in each tube. Any thoughts about this? I am a beginner.

Edited by JTO
Link to comment
Share on other sites

Quite bright, both. I like ‘em :)

Link to comment
Share on other sites

What white star formula did you use and what size star did you make?

Link to comment
Share on other sites

It looks good. I can get a similar effect using potassium perchlorate, atomized aluminum -325 mesh and phenolic resin, with about 1-2% fast burning pine air float charcoal (to help with ignitability - it increases burn speed a little as well.) The phenolic resin acts as the binder. The star is basically a silver / white streamer.

 

I'm assuming this is a modification to your chlorate based formulaI. Have actually done some experimenting with chlorates and aluminum as of recently. I was surprised to find that perchlorate in each case performed much better. Harder to ignite, but once ignited far better oxidation of the aluminum. Just basic tests so I can't say much, but my results were unexpected nonetheless.

 

Obviously, if you are mixing magnesium and chlorate... be careful. At least here the magnesium is coarse. If it is the coarse that is doing the job, I'd sieve out the fines as they would be introducing unnecessary risk.

Link to comment
Share on other sites

×
×
  • Create New...